Saturday, March 26, 2011

Custom made mount for water heater.

The heater I have was not able to be attached to the side of tank. It is made to attach to much smaller side of a fish tank. I went about making a custom mount for the heater and then attached it to the side of the frame on the NFT system and dropped it down to the level it needed to be at. I really hope this will get the temperature up to around 70 degrees. It was reading just under 60 when I put the thermometer in before installing the heater.

Used a little caulking to attach the heater to the wood. 

 Here the finished heater mount is attached to the side of the NFT sytstem frame.


No comments:

Post a Comment